CCTV
Keeping CCTV Recording During Load Shedding and Power Cuts
How to keep your CCTV cameras, recorder and phone alerts running through load shedding and outages: UPS vs lithium, sizing, runtime and common mistakes.
By the CPT Installation team · · 3 min read
Load shedding may come and go, but Cape Town still has scheduled outages, cable theft and storm-related power cuts. When the power goes off, a CCTV system without backup stops recording, and in many cases the router goes down too, so phone alerts stop. That is exactly the window opportunistic criminals look for.
The fix is not expensive. Here is how to do it properly.
What needs backup power
A camera system only works if every link in the chain stays on:
- The cameras. On an IP system these are powered by the recorder or a PoE switch. On an analogue system there is usually a separate power supply box.
- The recorder (NVR or DVR) and its hard drive.
- The router and fibre ONT, if you want phone notifications and live viewing during the outage.
Many people back up the recorder and forget the camera power supply or the router. The result is a recorder faithfully recording black screens.
Option 1: a UPS
A line-interactive UPS is the most common solution. It switches over in milliseconds, so the recorder does not reboot.
- Pros: affordable, simple, protects against surges and brownouts.
- Cons: lead-acid batteries inside most UPS units last around two to four years, and cheaper units only give an hour or so of runtime on a typical CCTV load.
A four-camera system draws roughly 30–50 watts. An eight-camera system with infrared on at night may draw 60–100 watts. A 1,000VA UPS will typically run a small system for one to two hours, which covers a normal load-shedding slot, but check the specific unit's runtime chart.
Option 2: a lithium (LiFePO4) backup
Small lithium power stations and DC UPS units designed for routers and CCTV are increasingly popular.
- Pros: much longer battery life (thousands of cycles), lighter, and many give four hours or more on a small system.
- Cons: higher upfront cost, and some cheaper units have a switchover gap that reboots the recorder. We check the transfer time before recommending a unit.
Option 3: your home inverter
If you already have a solar or backup inverter, the simplest fix is to put the CCTV recorder, camera power supply and router on the essential circuit. We often do this as part of a CCTV installation. Just make sure the inverter battery is sized for the extra overnight load.
How to size backup
A rough rule: add up the wattage of the recorder, cameras (including infrared at night) and router, then multiply by the hours you want to cover. Add 30% headroom. Four hours on a 60 W system needs about 310 Wh of usable battery.
Common mistakes
- Backing up only the recorder. Cameras on a separate supply go dark.
- Forgetting the router. Recording continues, but you get no alerts until power returns.
- Never testing. Flip the main switch once a quarter and check everything stays up.
- Ignoring surges. Power returning after an outage can spike. A UPS or surge arrester protects the recorder and power supplies, which are among the most common failures we repair on CCTV repair call-outs.
Do gate motors and intercoms need backup too?
Yes. Gate motors have their own battery, but it wears out. See gate motor batteries and load shedding. For a whole-house approach, read load-shedding-proofing your home security.
Get it done
We size and install backup power with every CCTV installation, or add it to an existing system. Ask for a quote.